
The IS type single-stage single-suction centrifugal pump is a common clean-water pump in industrial and civil applications, with simple structure, even flow and easy maintenance.
I. Pre-installation Preparation
Foundation: flat, solid, level to within 0.1 mm/m, with enough space for maintenance. Equipment check: verify model and specifications, inspect casing, impeller and shaft seal, and turn the shaft by hand for free rotation. Piping: avoid sharp bends on the suction side; fit a valve and pressure gauge on the discharge side; seal joints to prevent leaks and air ingress.
II. Start-up and Operation
Before start, vent air through the vent plug to prevent cavitation; jog the motor to confirm correct rotation; keep the outlet valve closed during start to reduce inrush current, then open gradually.
Monitor flow and pressure (investigate fluctuations over 10%), bearing temperature (must not exceed 75°C), and vibration/noise (stop immediately if abnormal). Stop by closing the outlet valve first, then stopping the motor, to avoid water hammer. For long shutdown, drain all water to prevent rust.
III. Maintenance
Check shaft-seal leakage every 3 months. Change bearing lubricating oil about every 500 operating hours, keeping the level at 1/2–2/3 of the sight glass. Replace worn impellers and wear rings promptly. When changing mechanical seals, keep the lapped faces clean and apply suitable grease. Paint the casing against rust; for corrosive media choose stainless steel or lined pumps.