When choosing pump-casing materials, consider: a) strength; b) corrosion resistance; c) abrasion resistance; d) casting and machining properties; e) repairability by welding; f) cost.
1. Cast Iron
For most clean-liquid applications, gray cast iron is a good casing material and is strong enough for single-stage pumps. Ductile iron is widely used at medium pressure and temperature. Where gray/ductile iron lacks corrosion resistance, high-nickel cast iron is used. A weldable high-nickel austenitic cast iron (D2W) containing a small amount of niobium has been developed. Typical austenitic cast iron contains 15–20% nickel and is widely used in brine.
Gray cast iron (Chinese grade HT) is the most common material for casings, impellers, covers and brackets of clean-water pumps, in grades HT150, HT200 and HT250. Ductile iron (QT) has mechanical properties close to steel with better castability and machinability, commonly QT450-10, QT500-7 and QT600-3.
2. Cast Steel
For corrosive petroleum products or multi-stage pumps with outlet pressure up to 13.8 MPa, specified cast steel or cast stainless steel is required. For boiler feed pumps and many hydrocarbon applications, martensitic stainless steel offers good mechanical properties for high pressure but less corrosion resistance. In chemical and corrosive services, austenitic stainless steel (CF-8M, CF-3M) is common. High-pressure subsea injection pumps use duplex stainless steel (50% ferrite + 50% austenite). Cast steel (ZG, e.g. ZG230-450) is generally used for pressure parts above 1.6 MPa.
3. Bronze
Bronze is also used for pump casings. Leaded bronze is common in small low-pressure pumps (lead aids sealing); tin bronze is used for larger centrifugal pumps. Nickel-aluminum bronze offers the best mechanical and corrosion properties but is expensive.
4. Composite Materials
To improve chemical resistance, linings of PTFE or rubber can be installed inside the volute. Solid ceramic and graphite pumps serve especially corrosive liquids such as hydrofluoric acid. In paper/pulp and metal-finishing industries, composites such as epoxy resin are used for casings.
5. Stainless Steel
Austenitic stainless steel (e.g. 0Cr18Ni9, 1Cr18Ni9Ti, 0Cr18Ni12Mo2Ti; known as SS304/SS316/SS316L abroad) is the most widely used corrosion-resistant material for chemical pumps, except for a few media such as hydrochloric and dilute sulfuric acid. Martensitic stainless steel (2Cr13, 3Cr13 / SS420) has better mechanical properties and is used for shafts and shaft sleeves. High-alloy (Alloy 20) and duplex stainless steels are also good corrosion-resistant choices.
6. Carbon Steel & 7. Alloy Steel
Plain carbon structural steel Q235 is used for plates and sections; quality carbon steel No.45 is widely used for pump shafts when corrosion is not a concern. The most typical alloy steel is 40Cr, used for high-strength pump shafts.
8. Non-metallic Materials
Non-metallic materials are mainly used for seals, such as PTFE, FKM and NBR. PTFE resists corrosion and high temperature, suiting almost all chemical media up to 250°C (though it is hard and difficult to assemble). FKM is a good heat- and corrosion-resistant seal material (up to about 160°C); NBR is mainly used for oil or clean-water static seals.